Eton Beamer Set-up Instructions
Page 1 of 5 Rev 3-10-06
1) Uncrate Scooter.
2) Inventory parts package (see check list)
3) Prep battery by adding electrolyte
(About 1 hour for battery to come to full
charge. DO NOT put on charger).
4) Install rear license plate holder with (2)
bolts & washer (20x8mm)
5)
Check tire pressure. Inflate to 25psi /
1.75kg/cm
2
6) Install handlebar mirrors using 14mm
wrench. (NOTE: Right hand mirror is
left-hand threaded)
7) Install the front turn signals using the
two screws provided.
8) Install the battery in the battery
compartment in the floor board.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com
Comments to this Manuals