E-TON MATRIX 50 Owner's Manual download pdf (Page 5)

Page 4 Rev 3.01 8-0904

Engine Stop Switch

The stop switch is a red colored rocker switch

located on the left-hand handlebar.

To start and run the engine, this switch must be

placed in the on, “O” position.

The vehicle is also equipped with a safety brake

switch which will prevent the engine from starting

until the parking brake is engaged.

To stop your engine, place the switch to the stop,

“X” position.

In the stop, “X” position the ignition system is

grounded preventing the spark plug from firing.

This switch can also be used as a safety or

emergency stop switch.

Turn Signal Switch

The turning signal switch is a three position

switch located on the left-hand handlebar. Sliding

the switch in the direction of the intended turn will

illuminate the front and rear turn signal lamps in a

blinking mode. Pressing the white button, on the

center of the switch, will return the switch to the

neutral position and cancel the illumination of the

turning lamps.

Horn Button

The horn button is a yellow push switch, located

below the turning signal lamp switch on the left-

hand handlebar. Pressing in on the button will

sound the audible horn signal. Releasing the

button will silence the horn.

Engine Manual Choke Lever

The engine choke lever is used to enrich the

fuel mixture when starting the engine from a

cold start. Start by moving the lever to the

left to choke the engine. After allowing the

engine to warm up for 15-20 seconds, slowly

move the lever back to the right until the

engine idles down runs smooth. The lever to

the full right is the normal operation position.

Head Light Control Switch

For safety, the head light system of this unit

was designed to be illuminated at all times

while the unit is running. The intensity of the

light is changed by using the head light

control switch located on the right-hand

handlebar. It is a three position slide switch.

Far right position sets beam intensity to 20%

(Day Time Running), middle position sets

beam intensity to 80% (Low Beam), and far

left position sets beam intensity to 100%

(High Beam).

The vehicle is equipped with a PTC controller

that will dim the lights to the 20% position

automatically if the engine RPM falls below

the pre-set threshold for more than a minute.

Increasing the engine RPM will return the

light to the normal level for the control switch

selection.

Control feature operations

1 2 3 4 5 6 7 8 9 10 ... 28 29

Comments to this Manuals

No comments

E-TON MATRIX 50 Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Scooters E-TON MATRIX 50